Basic Installation Steps
Safety Instructions
Before beginning your installation:
n
Read this entire Installation section so you can plan the installation from beginning to end.
n
Assemble all the tools and materials you require for the installation.
n
Be aware of all safety and electrical codes which must be met.
WARNING
ELECTRICAL SHOCK AND FIRE HAZARD
n
The power system must be designed by a certified vehicle solar system designer and installed
by a certified solar system technician.
n
All wiring should be done by qualified personnel to ensure compliance with all applicable
installation codes and regulations.
n
Disconnect all power sources.
n
Disable and secure disconnect devices.
Failure to follow these instructions can result in death, serious injury, or equipment
damage
Tools and Materials
You may need the following tools to install the Solar Max Flex Panel kit:
n
Screwdriver
n
Socket wrenches
n
Utility knife
n
DC clamp-on multimeter
n
Measuring tape
n
Pliers
n
Wire cutter
n
Safety gloves and eye protection
n
Rubber roller
n
Primer
n
Zip ties (provided as strain-relief devices)
n
Flange adapters (provided as needed in mounting)
n
30A solar charge controller (provided)
Installation Instructions
1. Plan the power system and prior to installing, check that the panel is producing power.
a.
Prepare the multimeter.
b.
Check out the weather to see if it is sunny.
c.
Partially unpack the solar panel, expose the cells to the sun and
test the output voltage using the multimeter's probes on the
solar panel's connectors.
d.
If the solar panel is functioning properly, the voltage reading
should be above 3VDC.
e.
Draw your power system on paper similar to
.
4
975-1172-01-01 Rev A
August 2023
