![background image](http://html.mh-extra.com/html/xantrex/808-0888/808-0888_owners-manual_881371008.webp)
Connection Terminals
8
Xantrex Gateway Owner's Guide
Connection Terminals
D
F
G H I J
A
B
E
C
A
Battery input power supply terminal (connect using the supplied power supply 2-pin connector with pigtail
to a 9-65V
Z
power source only).
B
micro-SD card slot for the supplied micro-SD card
c
Do not remove the micro-SD card.
C
Reset button - press to restore the Wi-Fi SSID and password to factory settings.
D
RJ-45 RV-C (CAN) port - connect to a compatible RV-C (CAN) device such as a compatible Xantrex
Freedom EX unit, Xantrex Freedom XC PRO unit, or a Xantrex Battery (PN: 884-XXXX-XX only).
c
If the Xantrex Gateway device is the end device of an RV-C (CAN) network, then you must turn on the
CAN terminator switch. Refer to
Activate RV-C (CAN Network) Internal Terminator on page 25
E
RJ-45 RS-485 Modbus port - connect to an RS-485 Modbus device such as a Xantrex MPPT Solar
Charge Controller (SCC)
F
NMEA 2000 [Micro-C (CAN)] port - connect to an auxiliary NMEA 2000 compatible device such as a
vessel monitoring system (VMS) or Freedom XC PRO Marine.
c
RESERVED FOR FUTURE USE.
G
RV-C (CAN) bus port - connect to an auxiliary device such as a compatible RV controller, a Xantrex
Freedom EX unit, a Xantrex Freedom XC PRO unit, or a Xantrex Battery (PN: 884-XXXX-XX only).
H
5V 0.5A USB host ports
c
DO NOT USE. RESERVED FOR FUTURE USE ONLY.
I
J
RJ-12 RS-232 ports
c
RESERVED FOR FUTURE USE.