INSTALLATION INSTRUCTIONS
WL85
Wall Link™
Plasma\LCD\LED\CFL Friendly
IR Receiver
+12VDC
STATUS
GND
IR OUT
W
L
8
5
IR
R
E
C
E
IV
E
R
Talkback LED
Status LED
IR
Receiver
®
2
DESCRIPTION
The WL85 is designed to reject interference from Plasma, LCD, LED
Displays and Compact Fluorescent Lamps (CFL) from entering the IR signal
line. This IR Receiver mounts easily into a single gang, electrical J-Box, is
supplied with mounting screws, and comes with a Decorator-style insert,
allowing the installer to use a Decorator-style wall cover plate. This provides
an integrated look for control of A/V equipment behind closed doors or any
IR Repeater System that is in close proximity to light sources described
above.
FEATURES
•
J-Box Mounting with Decorator-style insert (available in white (included),
ivory, almond, & black)
•
4-screw terminal block for interface to Xantech Connecting Blocks
•
Works in normal 3-wire mode
•
Improved Compact Fluorescent Light rejection
•
May be used in Direct Sunlight
•
RF Grid included for EMI reduction
•
Talk Back LED for IR reception and full system operation indication
•
Status LED for system On/Off indication (requires 12VDC Source
@10mA)
•
7 units may be powered by one 781ERGPS power supply (regulated
12VDC 200mA supply)
Note: The WL85 will not operate in 2-wire Phantom Power mode
SPECIFICATIONS
•
Infrared modulation frequency bandwidth: 30 - 60 kHz
•
Reception range: up to 80 feet (18M), depending on remote control
output strength and ambient conditions.
•
Reception angle: 55 degrees off axis at 50% range reduction
•
Cable requirements: 3-conductor. Use 24-gauge up to 200' (61M), 22
gauges up to 600' (180M), 20-gauge up to 2000' (600M), 18-gauge up to
5000' (1.5KM) -- unshielded OK.
•
Maximum transmission length: One mile using 18-gauge wire (1.6KM)
•
Maximum current output: 100 mA (pulse)
•
Dimensions: 1-3/4” W x 4-1/8” H x 1-1/8” D
•
Power requirements: 12 volts DC @ 20mA
