1
Emitters & Blasters
INSTALLATION INSTRUCTIONS
• The
MS1
is a black (IR opaque) 1" x 2" shield that fits over both the Xantech Mouse Emitter shell and the
IR sensor window of a controlled component. An optional accessory, it prevents unwanted external IR
signals from passing through it or leaking past it.
• The MS-1 also prevents IR from the Mouse Emitter from radiating backward into the IR sensors of other
components.
• It is especially useful for zone controlled applications where you want the equipment controlled only by
the Mouse Emitter fastened over the component IR sensors.
Install as follows:
1. Before removing the adhesive covers from the shield or the emitter, fit them together and temporarily
position them over the IR sensor window of the component.
2. When you have accurately determined the correct position for them, neatly trim the shield (if needed)
being sure that you leave sufficient material to overlap the extremities of the equipment’s IR sensor
window.
3. Remove adhesive covers from the shield and the emitter and stick them onto the IR sensor window.
MS1
MOUSE EMITTER SHIELD
Side View
Top View
Mouse
Emitter
Adhesive Layer
MS1
Mouse Emitter Shield
Controlled Component
MS1
and
Mouse Emitter
installed over IR sensor window. Trim
edges of MS1 as needed (see text).
Fig. 1
Using the MS1 Mouse Emitter Shield.
9-13-00
