XAG P100 Pro, Pilot Operating Handbook

Page: 88 / 184

XAG AUSTRALIA 88
Prepare the Remote Controller
P
reParing the
e
quiPment
Add Device – Remote Controller
01. Initiate the setup by inserting a Telstra or Optus SIM card into the ARC3 Pro device. The SIM slot,
labelled as "SIM 1", is conveniently located at the top of the controller.
02. With the ARC3 device switched off, take it outside. Locate the power button on the underside
of the controller. Press and hold the power button until all the indicator lights start to flash red.
You will also hear an auditory beep sound to confirm the action. As soon as you notice all lights
flashing red, you can release the power button.
03. After activating the controller, observe the flashing lights. They will transition from red to yellow
and ultimately to green. The green flashing lights indicate that the device is now in pairing mode
and ready to connect with other devices.
📖
INSTRUCTION
04. Now, on your mobile device, open the XAG One (ensure you're running version 4.6.21 or
higher). Navigate to the Accounts Menu and proceed to the (Device Menu. At the top
right corner of the page, tap the to add a new device.
Ⓝ
Notes
Please ensure that the controller is switched off before proceeding to Step 2.