X2E XORAYA ML-Z7, User Manual

Page: 12 / 208

U
SER
M
ANUAL
X
ORAYA
Z7 | X
ORAYA
ML-Z7
S
AFETY AND WARRANTY
12
2.2 General safety instructions
DANGER
Electric shock caused by damage to components
Any damage to the datalogger, power source or
connection cable may cause an electric shock.

Switch on the datalogger only if all components
appear undamaged.

Only commission the datalogger after a proper
installation or repair.
 Check the connecting cable regularly for defects to
prevent damage to the power source.
 Always install the datalogger in de-energized status.
WARNING
Defects influencing the environment
The incorrect datalogger configuration can lead to the
temporary or permanent functional failure of connected
vehicles.
Connected vehicles being operated on public roads bear
an increased risk of injury and damage.

If available, use configuration templates provided by
the vehicle manufacturer.

Use preferably the passive recording modes of the
interfaces.
CAUTION
Device damage due to short circuit
Bent connector pins pose a short circuit risk. This can lead
to abnormal behavior or destruction of the datalogger.
Likewise, devices connected to the measurement setup
may be also compromised.

Make sure that connector pins are not bent.
 Check the datalogger regularly for any deficiencies.
CAUTION
Device damage due to electrostatic discharge
Electronic components can be destroyed by electrostatic
discharge.

Avoid touching connectors and connector pins.
 Ground yourself before carrying the datalogger in
your hands.

Operate the datalogger in an ESD-compliant
environment.