Ninja
™
System Quick Setup Guide
Before you read the owner’s manual for the Ninja system it is recommended that you
follow the steps below to give the system a quick try. Later you can read the owner’s
manual to see how to connect the camera’s cord inside the top of the Ninja so you only
need one power supply.
Now connect the Receiver to your TV
●
Connect the Video Receiver to its power supply and plug
the power supply into an AC outlet near your TV.
●
Connect the Receiver to your TV using the RCA cable supplied.
●
Set the switch on the side of the Video Receiver to ON.
●
Turn your TV on and select Video mode. The Ninja’s power supply powers up in
the on state when you first plug it in, so you will now see a picture on your TV.
●
Point the “pip” on the Camera’s antenna and the “squares” on the Receiver’s
antenna towards each other for the best reception.
●
If you experience interference, try setting the Camera and Receiver to a different
letter channel (A, B, C, or D) - use the same letter on each (see instructions
included with them for more information).
Now try it out!
●
Insert 4 AAA alkaline batteries (not included) in the Remote Control.
●
Press the blue buttons at the top of the remote to pan the camera left and right,
and tilt it up and down.
Plug camera into power
supply included with it, and
plug power supply into an
AC outlet.
Squares
Pip
Wireless Technology, Inc.
For more information or help setting up your system,
please visit www.x10.com/support
Model VK74A
Plug Ninja into power
supply included with it, and
plug power supply into an
AC outlet.
Attach camera to top of
Ninja with screws provided.
!
"
#
Pr ogram
SC A N
Sw eep
C ent er
Nor mal
A
C
E
G
I
K
M
O
.
.
.
.
.
.
.
.
C A MER A
C2
C4
P OS ITIO N
P3
P2
C3
C1
P1
P4
Model XM14A*
Model XM10A
or XM13A*
* IMPORTANT! Do not interchange power
supplies. Model XM14A must be used only for the
Ninja Pan ‘n Tilt base.
