Page 144
160337-000 Rev D, 30 September, 2013
Xiotech—Proprietary
ISE User Guide
Maintenance
Change the Password
The
administrator
password can be changed from
administrator
(set by manufacturer) to a password of up to a
maximum of sixty-four alphanumeric characters. For excluded special characters when entering passwords
using the Web-Mgt and CLI, see “Characters—Web-Mgt and CLI” on page 29. The password is case-sensitive.
Password—Web-Mgt
To change the user password using the Web-Mgt:
1. Choose
Users
>>
change password
to select the Change Password view.
The user name (
administrator
) appears in the
Username
field.
2. Enter the new user password in the
New Password
field.
3. Re-enter the new user password in the
Verify Password
field.
If the two passwords do not match, a password mismatch dialog appears.
4. Click
OK
and re-enter the password in both the New and Verify fields.
5. Click
Save Changes
and the System Authentication dialog appears.
6. Enter the new password in the Password field.
7. Select the
Remember my password
checkbox if the Password field should be populated at every login.
8. Click
OK
; the password is remembered and the At-A-Glance Summary view is displayed.
Password—CLI
To set the user password using the CLI, use the
configure --password=
<new_password>
command.
Note.
When changing the password using the CLI, the console displays the password characters as they
are entered. Exercise care in typing and reviewing the password, as the CLI does not provide a password
verification step.
The CLI console displays the message
Changing password for administrator
followed by a list of
configurable parameters.
Transferring DataPacs
When transferring DataPacs between like model ISEs when one ISE is configured to run with a fixed Fibre
Channel speed and the other ISE is configured to run in Autonegotiate mode, the following steps must be
taken:
1. The receiving ISE must be in a shipped from manufacturing state (not yet initialized).
Note.
When the receiving ISE is a spare that has been initialized, the ISE must be reformatted. The
REFORMAT ISE
warns not to proceed as data will be lost. That is, any data on this ISE will be
destroyed by the reformat. Only proceed if this is acceptable.
2. Determine the Fibre Channel speed setting on the transferring ISE and recorded it for later as this setting
is not retained during the DataPac transfer process.
3. Shut down both ISE units.
4. Pull any Fibre Channel cables from the receiving ISE.
5. Pull the DataPacs being transferred—DataPac pairs always remain paired.
6. Power on the receiving ISE and let it boot up.
Summary of Contents for ISE-2 Series
