WYTRON CD-398, Operation Manual

Page: 49 / 58

49
6.9 Reset
The reset procedure is required for several reasons such as:
First assembling of duplicator, changing new brand of
writers in old duplicator, wrong setting for certain function or
bring back the factory’s default setting according to different
usages. Our design provides an easy way for customer to
reset their controller cards as below:
1. Turn off the power of duplicator and wait for 10 seconds. If
the duplicator is not used at this moment, ignore this step
and go to procedure 2 directly.
2. Press and hold down the MODE switch and turn on the
power of duplicator simultaneously (the MODE switch
must be held down at least 5 seconds while turning on the
power of duplicator).
3. Release the MODE switch after the message of “clear
setup” is shown on the top line of LCD display.
4. If the “clear setup” message is not shown, please repeat
the whole procedure above but remain the finger on
MODE switch all the time during power on till you see the
message of “clear setup” on LCD display.
5. All setting on duplicator will be restored to its factory
default setting after the “clear setup” message shown on
the LCD display, which is a correct reset procedure.
(Unlike the Update procedure which will keep the settings
the same before BIOS Update.)