Wyse 3315SE, Reference Manual, Page: 87 / 260

11
Initial Terminal Setup
Using the Setup Wizard
The Setup Wizard is used for initial setup of the terminal’s properties. The wizard
runs when:
• You power-up your terminal for the first time.
• Your terminal has been restarted with a G key reset (described later).
• A new image has been downloaded to your terminal but is older than the image
currently in use.
• You use the Reset the Terminal to Factory-Default Property Settings
function on the General properties sheet.
The
Setup Wizard
lets you set terminal network configuration and terminal display
parameters. Any future changes can be made using the
Terminal Properties
dialog box. You can launch this dialog box from the
Winterm Connection
Manager
by pressing the
F2
key. See “Resetting Terminal Properties.”
There are seven dialog boxes that display in succession during the process. Each
dialog box is self-explanatory. Some dialog boxes are informational and require no
user input. Other dialog boxes will prompt you for network and display information.
Following are the seven dialog boxes of the wizard.