Wyse 3315SE, Reference Manual

Page: 78 / 260

54
Installation Procedures
Installation and Removal
The modem card can be configured to connect
• To a server via PPP
• Directly to an ICA server
• To a server with a terminal emulation
Note
This procedure assumes that the terminal is already
installed and configured as described in “Terminal
Installation.”
Note
This procedure is based on the modem card and cable
sold by the terminal manufacturer. Installation will be
similar for other modem cards and cables.
Installation
Refer to the following three figures and proceed as follows:
1. Turn off the power.
2. Remove the screw beneath the security cover.
3. Open the cover over the option slot.
4. Press down on top of the cover to release the top catches and swing the cover
out and down (see the next figure).
Caution
Do not try to open the cover with the logic card
assembly fully seated. The cover could be damaged.
5. Insert the modem card (with product label up) into the option slot and press it
gently until it is seated in the card receptacle.
Note
If a plug is installed in the cover’s rear hole, remove the
plug before proceeding. Save the plug for possible
future use when the card is removed (see figure 9.4).