Wyse 3315SE, Reference Manual, Page: 71 / 260

47
Follow these instructions to connect the terminal to its peripheral devices:
1. Connect the keyboard to the Keyboard connector.
2.
Connect the mouse to the Mouse connector.
3. Plug the AC cord into the back panel of the terminal, then into an AC outlet.
4. Connect a 10Base-T network cable to the Network connector.
The terminal is now ready for operation.
Turning On the Terminal
Once the terminal is installed and all back panel connections have been made,
power it up. If the terminal is a 3515SE or 3715SE, press and release the power
management button. If the terminal is a 3720SE, it is powered-up and operating
when it is connected to AC power; to toggle the display off or on, press and release
the power management button.
Note
For the 3720SE, if the button is continuously depressed
for 3-5 seconds, the unit will perform a hard boot.
See the figure on the following page for the location of the power management
button.
Parallel Port Local printer output
Keyboard Keyboard interface
Mouse Mouse interface
Power AC power cord interface
Option Slot PCMCIA card slot
Headphone Audio output for headphones
Microphone Audio input for microphones
Table 8-1 3515SE/3715SE/3720SE Terminal Back Panel Connectors,
Connector Description