2x1 HDMI/VGA Smart Switch
with CEC Control
SW-0201-4K
Quickstart Guide
In the Box
1x SW-0201-4K Smart Switch
1x 12V DC 0.5A Power Supply (US/UK/EU)
2x 3-pin Screw Down Phoenix Connector
1x 5-pin Screw Down Phoenix Connector
2x Mounting Brackets
1x Quickstart Guide (this document)
Basic Wiring Diagram
KEY
HDMI/Digital Video RS-232
Power Analog Video Analog Audio
HDMI from Source
RS-232 to
Control
System
Analog Video
Analog Audio
HDMI Source
HDMI Display
VGA Source
HDMI to
Display
Keypad Source Button
Keypad Source LED
12 DC 0.5A
Power Supply
IMPORTANT!
Do not connect or disconnect (hot plug) the HDMI, or HDBaseT
connections while the transmitter or receiver is powered on. Doing so
may cause damage to the units or connected devices.
Additional Information
This Quickstart Guide provides the basic steps for the common uses of
this product. Refer to the Installation Guide and other documentation on
the product page for additional information.
Installation
Before Beginning
Verify that all items are included in the packaging per the
In The Box
list.
Pre Wire
1.
(Optional) If using VGA with Audio, run the wire and terminate per
the
Audio In Wiring
section.
2.
(Optional) If using RS-232 to control the switcher, run the wire and
terminate per the
RS-232 Wiring
section.
3.
(Optional) If using a keypad or panel switch to control the switcher,
run the wire and terminate per the
Source Contact Closure Wiring
section.
4.
(Optional) If using a keypad or panel switch to turn CEC On/Off, run
the wire and terminate per the
CEC Contact Closure Wiring section.
Installation
1.
Connect an HDMI source to the
HDMI In
on the transmitter using
an HDMI cable from a high quality brand such as
WyreStorm
Express.
Refer to the
HDMI Wiring
section for important HDMI
wiring guidelines.
2.
(Optional) Connect the VGA Out from a VGA source to a
VGA In
on
the switcher. Connect the audio out for the VGA source to the
Audio
In
using the cable created in
Pre Wire
step 1.
3.
(Optional) Connect the 3-pin connector to the
RS-232
port on the
switcher and the opposite end to a port on a control system using
the cable created in
Pre Wire
step 2.
4.
(Optional) Connect the 5-pin connector to the Source port on the
switcher and the opposite end to a keypad or panel switch using the
cable created in
Pre Wire
step 3.
5.
(Optional) Connect the 3-pin connector to the
CEC Link
port on the
switcher and the opposite end to a keypad or panel switch using the
cable created in
Pre Wire
step 4.
6.
Connect the included 12V DC 0.5A power supply to the DC 12V
input.
Copyright © 2015 WyreStorm Technologies |
wyrestorm.com
SW-0201-4K Quickstart Guide | 151222
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
1 of 4
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the
installation process.
Compact device to switch a VGA or HDMI source to a single HDMI output. CEC-Link ensures the sink device is powered on during use.
