4K UHD HDBaseT Receiver with 5Play
and 2-way PoH (70m/230ft)
RX-70-4K v2
Quickstart Guide
In the Box
1x RX-70-4K Receiver
1x Wide-band IR Emitter
1x Wide-band IR Receiver (30-50KHz)
2x Mounting Brackets
1x 3-pin Phoenix Connector
1x 2-pin Phoenix Connector
1x Quickstart Guide (this document)
Basic Wiring Diagram
IR
Key
HDMI/Digital Video
HDBaseT/Ethernet
RX-70-4K
H2 Matrix with ARC
2-Way
UHD Display
Control System
HDMI
Note:
The RX can power a transmitter
via PoH when a PSU is connected to the 12V DC In.
Note:
Not required if powering
the receiver via PoH.
Ethernet
IR RX
IR TX
IR RX
CAB-IR-LINK (Sold Separately)
12V DC 2A
IMPORTANT!
Disconnecting and connecting (hot plugging) HDMI or HDBaseT while devices
are powered on may cause damage. WyreStorm recommends powering off
devices before disconnecting these connections.
Recommended Products
To take full advantage of the features of this receiver, WyreStorm
recommends the following products be used within the system.
• CAB-IR-LINK
– Use this cable when using an IR control system for matrix
control of HDBaseT pass-through.
Additional Information
This Quickstart Guide provides the basic steps for the common uses of this
product. Refer to the Installation Guide and other documentation on the
product page for additional information.
Before Beginning
WyreStorm recommends visiting the product page before installing this
product for updates to this Quickstart Guide as well as other information
about the product.
• Verify that all items are included per the
In The Box
list.
Pre Wire
1.
Run a Cat5e/6/6a cable from the transmitter location to the receiver
location no longer than 70m/230ft (4K UHD) and 100m/328ft (1080p).
Terminate the cable per the
HDMI/HDBaseT Wiring
section.
2.
(Optional) If using 3rd party IR emitters or connecting blocks at either
the transmitter or receiver, run the wire and terminate per the
IR TX
(Emitter) Wiring
section.
3.
(Optional) If using RS-232 pass-through, run the wire and terminate per
the
RS-232 Wiring
section.
4.
(Optional) If using 3rd party IR receivers at either the transmitter or
receiver, run the wire and terminate per the
IR RX (Receiver) Wiring
section.
Receiver Installation
1.
Connect the
HDMI Out
on the receiver to an input on the display using
an HDMI cable from a high quality brand such as
WyreStorm Express.
2.
Using the cable created in
Pre Wire
step 1, connect the 8-pin RJ-45
female plug to the
HDBT In
jack.
3.
(Optional) Place an IR emitter onto the display device near the device’s
IR sensor and connect it the
IR TX
port.
4.
(Optional) If using RS-232 pass-through, connect the 3-pin connector
to the
RS-232
port on the receiver and the opposite end to a port on the
device being controlled.
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
RX-70-4K v2 Quickstart Guide | 160818
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
1 of 4
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the installation
process.
Note:
The following information applies to version 2 of this product as identified by v2 after the model number on the product label.
