NHD-600-TRX
Quickstart Guide
4K60 4:4:4 10GbE SDVoE Transceiver w/ PoE+,
Video Wall, Multiview Processing & USB
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the
installation process.
IMPORTANT! Installation Requirements
IMPORTANT! Installation Requirements
Copyright © 2021 WyreStorm Technologies |
NHD-600-TRX Quickstart Guide | 211108
INT: +44 (0) 1793 230 343 | US: 844.280.WYRE (9973)
1 of 4
WyreStorm Documentation and Firmware
Download the following items from the product page on wyrestorm.com. They are essential for accurate configuration and use of the NetworkHD system.
• Latest NetworkHD Firmware
• Management Suite v1.9 or Higher
• NetworkHD Installation Guide
• NetworkHD Technical Reference Guide
• NetworkHD Certified Switches
• NetworkHD Switch Configuration Guides
• NetworkHD Switch Mapping Worksheet
• 3rd Party Control System Drivers
Network Switch Requirements
• WyreStorm highly recommends the use of switches listed in the NetworkHD Certified Switches. These switches have been verified by WyreStorm to meet the
requirements of a NetworkHD system.
• NetworkHD requires a Layer 2+ / Layer 3 managed switch network with support for Multicast & IGMP Snooping. Ensure that the switch being used supports
these features and that they are configured prior to connecting the NetworkHD system.
• Configure all network switches to the exact specifications contained in the WyreStorm Switch Configurations Guides prior to connecting the NetworkHD
system. This will ensure proper operation from startup.
• The use of patch panels, wall plates, cable extenders, kinks in cables, and
electrical or environmental interference will have an adverse effect on
signal transmission which may limit performance. Steps should be taken
to minimize or remove these factors completely during installation for
best results.
• WyreStorm recommends using pre-terminated HDMI and DP cables due
to the complexity of these connector types. Using pre-terminated cables
will ensure that these connections are accurate and will not interfere with
the performance of the product.
Wiring and Connections
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in this
entirety before running or terminating the wires to ensure proper operation and to avoid damaging equipment.
LAN Port Wiring
The NetworkHD Series LAN port is a 1GbE link for connection to a
1000BASE-T Ethernet device port. Refer to IEEE 802.3ab for official
guidance on the Ethernet link. Cables must be tested to 100MHz across the
entire link. 1000BASE-T uses the IEC 60603-7 8P8C modular connector.
HDMI/DVI Wiring
WyreStorm recommends using pre-terminated HDMI and DVI cables due to
the complexity of these connector types. Using pre-terminated cables will
ensure that these connections are accurate and will not interfere with the
performance of the product.
Warranty Information
WyreStorm Technologies LLC warrants that its products to be free from defects in material and workmanship under normal use for a
period of five (5) years from the date of purchase. Refer to the Product Warranty page on
for more details on our limited
product warranty.
