70m/230ft 2K HDMI Extender
with IR control and CEC pass-through
EX-70-G2
Quickstart Guide
In the Box
1x EX-70-G2 Transmitter
1x EX-70-G2 Receiver
1x 18V DC 1A Power Supply (US/UK/EU)
1x Wide-band IR Emitters
1x Wide-band IR Receivers (30-50KHz)
4x Mounting Brackets (1pr for TX and 1pr for RX)
1x Quickstart Guide (this document)
Basic Wiring Diagram
HDMI Display
HDMI
HDMI
IR Emitter
IR Emitter
IR Receiver
18V DC 1A
Power Supply
IR to Control System
CAB-IR-LINK (Sold Separately)
EX-70-G2 Transmitter (TX)
EX-70-G2 Receiver (RX)
HDMI Source
KEY
HDMI
HDBaseT Cat5e/6/6a
IR TX and RX
Power
HDBaseT
Cat6/6a/7
or
IMPORTANT!
Disconnecting and connecting (hot plugging) HDMI, or HDBaseT while
devices are powered on may cause damage. WyreStorm recommends
powering off devices before disconnecting these connections.
Additional Information
This Quickstart Guide provides the basic steps for the common uses of this
product. Refer to the Installation Guide and other documentation on the
product page for additional information.
Installation
Before Beginning
• Verify that all items are included in the packaging per the
In the Box
list.
Pre Wire
1.
Run a Cat5e/6/6a cable from the transmitter location to the receiver
location. Terminate the cable per the
HDMI/HDBaseT Wiring
section.
2.
(Optional) If using 3rd party IR emitters or connecting blocks at either
the transmitter or receiver, run the wire and terminate per the
IR TX
(Emitter) Wiring
section.
3.
(Optional) If using 3rd party IR receivers at either the transmitter or
receiver, run the wire and terminate per the
IR RX (Receiver) Wiring
section.
Transmitter Installation
1.
Connect an HDMI source to the
HDMI In
on the transmitter using an
HDMI cable from a high quality brand such as
WyreStorm Express
.
2.
(Optional) Place an IR emitter onto the source device near the device’s
IR receiver and connect it the
IR TX
port.
3.
Connect the cable created in
Pre Wire
step 1 to the
HDBT Out
.
4.
If using PoH from the transmitter to power the receiver, connect the
included 18V DC 1A power supply to the
18V DC 1A
jack.
Receiver Installation
1.
Connect the
HDMI Out
on the receiver to an input on the display using
an HDMI cable from a high quality brand such as
WyreStorm Express
.
2.
(Optional) Place an IR emitter onto the source device near the device’s
IR receiver and connect it the
IR TX
port.
3.
Connect the cable created in
Pre Wire
step 1 to the
HDBT In
.
4.
If not using PoH from the transmitter to power the receiver, connect the
included 18V DC 1A power supply to the
18V DC 1A
jack.
Copyright © 2017 WyreStorm Technologies |
wyrestorm.com
EX-70-G2 Quickstart Guide | 170724
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
1 of 4
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the
installation process.
