WWBeds Face Unassembled Alpha Murphy, Assembly Instructions Manual, Page: 15 / 18

L-5 Attach the connector bar to the legs using
the 1-¼ bolts and star washer. See diagram.
L-6 Feed the 1 ¼” bolt with the star washer
thought the hole in the leg and into the Steel
Leg Rod. Tighten with a 7/16” wrench or
socket. Be careful not to over tighten. Repete
for the other side.
L-7 Check operation of the leg. Loosen or
tighten the Nylock Nut from step L-4.
Mounting the Face
Video: ​ Mounting the Face
6-1. Lift the unit vertically to a height where the bolts in holes #3 are several inches above the top of the
Tension Arms. Gently fit the unit between the arms, tilt it back approximately 10 degrees so that the head end
of the until clears the Bottom Kick, then lower it so that the #3 bolts slide into the slots at the end of the Arms.
Be sure the Allen Head cap seats at the bottom of the slots on the tension arm. ​ Slowly tilt the panel unit
back just enough to allow the #1 Allen Head Cap bolts to be fully seated in the notches at the bottom of the
Mechanism. As in Drawings 14, 15, and 16.
6-2 Continue to tilt the Bed Panel Unit outward to an angle of about 45 degrees, during which action you will
hear a click as the Arm Locks disengage. With your assistant holding the bed at roughly this angle, install the
#2 bolts and Nuts. Still holding the panel unit at this angle securely tighten the #2 and #3 nuts.
6-3 When all bolts are securely tightened, you may tilt
the panel outward to approximately 45 degrees to
release the arm locks. You will hear a click as they
disengage.