wtw TresCon UNO A111, Operating Manual

Page: 110 / 208

Operation TresCon UNO
5 - 54 ba43134e08 05/2017
5.4.3 Recorder function, Record of measured values
With the Record of measured values function, the recorder output pro-
vides a current that is independent of the measured value. With the
Recorder , Recorder Beginning , Recorder End Point and di/dt parame-
ters, the output of measured values is defined.
Settings
Note
The setting of the recorder parameters is described in section
5.4.2 S
ETTING UP THE RECORDER
.
5.4.4 Recorder function, Controller
Setting Selection/Values Explanation
Recorder 0 - 20 mA
4 - 20 mA Signal range of the
recorder output
Recorder Beginning within the measu-
ring range
(depending on the
analyzer module) Note:
Minimum distance:
10% of the measuring
range
Recorder End Point
di/dt 0.1 mA/s
1 mA/s
5 mA/s
10 mA/s
20 mA/s Attenuation: Speed of
change of the output cur-
rent in the case of an
erratic change of the
input signal.
Response with stop any in the range
0 ... 20 mA
In the Stop mode, the
current output provides
the defined current
value. Also in the case of
AutoCal , AutoClean etc.
Hold The current at the output
remains unchanged.