Firmware update
Multi 9310
94
ba75937e03
12/2011
16 Firmware update
16.1 Firmware update for the meter Multi 9310
You can find available firmware update files for your meter on the Internet. With
the "Firmware Update " program and a PC you can update the firmware of the
Multi 9310 to the newest version.
For the update you have to connect the meter to a PC.
For the update via the USB-B interface, the following is required:
z
a free USB interface (virtual COM port) on the PC
z
the driver for the USB interface (on the enclosed CD-ROM)
z
the USB cable (included in the scope of delivery of the Multi 9310).
After switching the meter off and on you can check whether the meter has taken
over the new software version (see Y
1.
Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the meter (or meter type), the new
data are displayed there.
2.
In the windows start menu, open the update folder and start the firm-
ware update program for the meter
3.
Using the USB interface cable, connect the Multi 9310 to a USB inter-
face (virtual COM port) of the PC.
4.
Switch on the Multi 9310.
5.
In the firmware update program, start the update process with OK.
6.
Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 15 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
7.
Disconnect the Multi 9310 from the PC.
The Multi 9310 is ready for operation again.
Summary of Contents for Multi 9310
Page 101: ......
