wtw MIQ/Blue PS SET, Operating Manual

Page: 22 / 46

Installation MIQ/Blue PS
3 - 12 ba75573e04 05/2009
3.6 Connecting the voltage supply
The following two sections need only be observed if the
IQ S
ENSOR
N
ET
island should be supplied with power by the MIQ/
Blue PS.
3.6.1 Connection to 100 ... 240 V AC
Warning
If the power supply is connected incorrectly, it may represent a
danger to life from electric shock. Pay attention to the following
points during installation:
z
The MIQ/Blue PS may only be connected by a trained
electrician.
z
The connection of the MIQ/Blue PS to the power supply may
only be carried out when it is not carrying any voltage.
z
The power supply must fulfill the specifications given on the
nameplate and in chapter 6 T
ECHNICAL DATA
.
z
When installed in a building, a switch or power switch must be
provided as an interrupt facility for the MIQ/Blue PS.
The interrupt facility must
– be installed in the vicinity of the MIQ/Blue PS, easily
accessible by the user, and
– be labeled as an interrupt facility for the MIQ/Blue PS.
z
After it has been installed, the MIQ/Blue PS may only be opened
if the mains voltage has been switched off beforehand.
Materials required
z
Wire end sleeves, suitable for the power line, with suitable crimping
tool
z
1 x cable gland, matched to the cable diameter (see section 3.5 on
page 3-10).
Tools
z
Cable stripping knife
z
Wire stripper
z
Phillips screw driver
z
Small screw driver.