wtw MIQ/Blue PS SET, Operating Manual

Page: 19 / 46

MIQ/Blue PS Installation
3 - 9 ba75573e04 05/2009
In addition, you need two SMA reverse adapters. Example:
Supplier: Conrad Electronic SE
Klaus-Conrad-Str. 1
92240 Hirschau
Germany
http://www.conrad.de
Types: 1.) SMA reverse connector to SMA socket,
Conrad product ID: 734131
2.) SMA connector to SMA reverse socket,
Conrad product ID: 734145
For the test, insert the attenuator and both adapters between the
antenna connector of the module enclosure and the antenna of one of
the two MIQ/Blue PS and remove the attenuator again after the test.
If the radio connection works faultlessly with the attenuator, you can
assume that the radio link will also work faultlessly under unfavorable
conditions (e.g. bad weather).
3.4 Installation in the IQ S
ENSOR
N
ET
The IQ S
ENSOR
N
ET
provides a number of options for integrating the
MIQ/Blue PS mechanically and electrically in the system (stacked
mounting, distributed mounting, etc.). The individual types of
installation are described in detail in the I
NSTALLATION
chapter of the
system operating manual.
Note
If there are several power supply modules in the IQ S
ENSOR
N
ET
, it is
helpful if all the power supply modules are connected to a single power
supply. As a result, the system can be easily switched on and off from
a single location.