wtw IQ SENSOR NET System 2020 XT, Operating Manual

Page: 64 / 216

Installation System 2020 XT C
ONNECT
3 - 36
ba75970e01 10/2012
General installation
instructions
Observe the following points when attaching connecting wires to the
terminal strip

Shorten all the wires to be used to the length required for the instal
-
lation

Always fit all the ends of the wires with wire end sleeves before con
-
necting them to the terminal strip

Any wires that are not used and project into the enclosure must be
cut off as closely as possible to the cable gland.

Screw a small cable gland with sealing ring into each remaining free
opening and close it with a blind plug.
Warning
No free wires must be allowed to project into the enclosure. Otherwise,
there is a danger that areas safe to contact could come into contact
with dangerous voltages. This could result in life threatening electric
shock when working with the IQ S
ENSOR
N
ET
. Always cut off any wires
that are not in use as closely as possible to the cable gland.
3.8 Connecting the voltage supply
How to connect the voltage supply is comprehensively
described in the operating manual of the MIQ power supply
module.