wtw IQ SENSOR NET MIQ/PS, Operating Manual

Page: 9 / 20

MIQ/PS Installation
3 - 1 ba64113e02 12/2005
3 Installation
3.1 Scope of delivery
The scope of delivery of the MIQ/PS is listed in the I
NSTALLATION
chapter of the system operating manual.
3.2 Installation in the IQ S
ENSOR
N
ET
The IQ S
ENSOR
N
ET
provides a number of options for integrating the
MIQ/PS mechanically and electrically in the system (stacked mounting,
distributed mounting, etc.). The individual types of installation are
described in detail in the I
NSTALLATION
chapter of the system operating
manual.
Note
To achieve optimum heat transfer, it is recommended to always place
the power supply module at the back of a module stack.
Note
If there are several power supply modules in the IQ S
ENSOR
N
ET
, it is
helpful if all the power supply modules are connected to a single power
supply. As a result, the system can be easily switched on and off from
a single location.
3.3 Connecting the power supply
Warning
If the power supply is connected incorrectly, it may represent a
danger to life from electric shock. Pay attention to the following
points during installation:
! ! ! !
The MIQ/PS may only be connected to the power supply by a
trained electrician.
! ! ! !
The connection of the MIQ/PS to the power supply may only be
carried out when it is not carrying any voltage.
!
! !
!
The power supply must fulfill the specifications given on the
nameplate and in chapter 5 T
ECHNICAL DATA
.
! ! ! !
When installed in a building, a switch or power switch must be
provided as a disconnecting device for the MIQ/PS.
The interrupt facility must:
– be installed in the vicinity of the MIQ/PS, easily accessible by
the user, and
– identified as a disconnecting device for the MIQ/PS.
!
! !
!
After it has been installed, the MIQ/PS may only be opened if
the mains voltage has been switched off beforehand.
Luggage Point WRP Water Reclamation (MIQ/PS) Vendor Manual
Doc Id: 006465 Active: 02/04/08 Page 9 of 20