wtw inoLab 740, Operating Manual

Page: 220 / 274

Data output
220
12.2.4 Printing
Printing the display When the
p
softkey function is shown on the display you
can always print the current display. Use the
p
softkey to
print the following data:
l
The data record of the current measured value
l The data record of a stored measured value
l
The graphical representation of a measured data series
stored with AutoStore (only on the integrated printer)
l Calibration records
You can also start a printout of the current numerical data
record on the measuring module.
Precondition: AutoRead is not active.
Printing
stored
data records
If there are stored measured values, you can display and
print them.
1 Start the printout of the currently displayed numerical
or graphical data with
p
.
1 Start the printout of the currently displayed numerical
data with
g
.
1 Switch to the Display mode.
2 Switch to the storage display with
r
.
3 Call up the RCL menu with [RCL menu] .
4 Option:
Determine the selection criteria for the data in the
RCL filter input window (see section 11.1.3)
5 Select the Print all menu item with
82
.