wtw DIQ/S 182-XT-4, Operating Manual

Page: 90 / 152

The SETTINGS menu System 182-XT-4
5 - 4 ba75753e06 12/2014
5.4 Outputs D00 to Dxx
These two menus can be used to link the sensors with the relay and
current outputs of the DIQ/S 182-XT-4 and setting the outputs. The
various setting options are described in detail in the chapter 6 O
UTPUTS
menu.
5.5 System
The settings in the SYSTEM menu comprise:

Date/Time

Pressure/Altitude
This setting is important if you want to carry out D. O. measurements
with the System 182.
(adjustable range: 500 ... 1100 mbar or 0 ... 5955 m altitude).

Settings
a
/
z?
Here you can configure the password for the settings.
For details on the passwords, refer to section 4.6.

Calibrate
a
/
z?
Here you can configure the password for calibration.
For details on the passwords, refer to section 4.6.

Display contrast
Here you can set the display contrast for optimum readability.

Delivery state
Here you can reset all settings to the default values. Only the date,
time and contrast setting for the display will remain stored. If the
settings password is active, a password prompt appears before the
reset. In any case a security prompt appears to prevent an
inadvertent reset.
3 Select Delete dataset with
d
and confirm with
g
.
The dialog window for the security prompt appears.
4 Select Delete dataset with
d
and confirm with
g
.
The inactive sensor is erased.