wtw DIQ/S 182-MOD, System Operating Manual

Page: 62 / 150

Operation System 182
4 - 2 ba75504e07 04/2012
4.2 Measured value and status display
With the
m
key you switch to the last selected measured value and
status display from any operating situation. Entries that are not
completed are ignored while doing so.
By pressing
m
once again you cyclically switch between further
display options.
Example:
Display options
with two connected
sensors
Operating notes

Select a sensor in the double display with
w
. The selected sensor
is displayed in reverse video. The number and name of the selected
sensor are displayed in the header. In the single display, the sensor
being displayed is always the selected sensor at the same time.

Start a calibration procedure for the selected sensor with
c
.
Starting a calibration procedure from the display of interfaces is not
possible.
Big double display:
Main measured parameter only.
Detailed double display:
Main and secondary measured
parameter.
Single display.
The display switches between the
connected sensors every
3 seconds.
Display of the interfaces.
Either:
Date and time and the current
states of the relays.
Or (switchable with
w
):
State of the Modbus
communication.