wtw DIQ/S 182-MOD, System Operating Manual, Page: 116 / 150

Modbus connection System 182
7 - 6 ba75504e07 04/2012
Query and response
telegram
Data transmission takes place via query and response telegrams. The
form of the telegrams is determined by the Modbus RTU protocol.
The Modbus master transmits a query telegram with a Modbus
command to the Modbus slave (here, the DIQ/S 182-MOD). The
Modbus slave transmits a response telegram with the requested data
from the sensor data block or an error message.
Supported
Modbus commands
The DIQ/S 182-MOD provides the data block for read access only.
Writing Modbus commands are not carried out.
7.4.2 Sensor administration under Modbus
Preparation of the IQ S
ENSOR
N
ET
for communication with the Modbus
may require, e.g. the following:

Creating an IQ S
ENSOR
N
ET
system with specific assignment of
sensor numbers to sensors

Creating several IQ S
ENSOR
N
ET
systems with the identical
assignment of sensor numbers to sensors

Changing the order of the sensors in an already installed system
Creating the assignment
of sensor numbers
You want to install an IQ S
ENSOR
N
ET
system and, at the same time,
create a specific sequence of sensor number assignments to the
sensors.
Modbus commands Command code
Read Input Register 04h
Read Discrete Inputs 02h
Read Holding Register 03h
Read Coils 01h
1 Carry out a system start without any sensors (see section
3.10).
2 Connect the sensors to the system in the required order. With
each sensor wait until the system has recognized the sensor.