wtw DIQ/S 181, Operating Manual

Page: 66 / 104

Outputs
DIQ/S 181
66
ba77083e01 02/2015
6.2.3 Setting outputs
Proceeding: setting an
output
6.3 Basic information on relay functions
This chapter describes general basic information concerning the
following relay functions:

Monitoring (see section 6.3.1)

Limit indicator (see section 6.3.2)

Proportional output (see section 6.3.3)
1 Open the SETTINGS menu with <S> .
2 Using <

> and <OK> , select and confirm the Relay output
Rx menu item (corresponding to relay 1, 2 or 3) or mA output
Cy menu item (corresponding to current output 1 or 2).
3 Confirm the selection of Set output with <OK> .
The setting table of the output is displayed.
4 Edit the setting table as described in section 4.3.2.
To accept all settings, highlight the Save and quit menu
item at the lower end of the setting table and press <OK> .
If you exit the setting table via <M> , <ESC> / Quit or the Quit
menu item, all changes are ignored.