5-42
Basic Configuration
5.9.3.1. Adding IP Addresses to the Allow and Deny Lists
To add an IP Address to the Allow or Deny list, and begin configuring the IP Security
feature, proceed as follows.
Notes:
• Both the Allow and Deny list can include Linux operators, wild cards, and
net/mask pairs.
• In some cases, it is not necessary to enter all four "digits" of the IP Address.
For example, if you wish to allow access to all IP addresses that begin with
"192," then you would only need to enter "192."
• The IP Security Configuration menu is only available when the Administrator
Mode is active.
• In order to use domain names in the Allow List and/or Deny List, you must
first define IP address(es) for the desired Domain Name Server(s) as
described in Section 5.9.5.
1. Access the IP Security Configuration Menu.
a)
Text Interface:
Type
/N
[Enter]
to display the Network Configuration Menu.
From the Network Configuration Menu, type
5
[Enter]
to display the IP
Security Menu.
b)
Web Browser Interface:
Place the cursor over the "Network Configuration"
link on the left hand side of the screen. When the fly-out menu appears, click
on the "IP Security" Link to display the IP Security Menu.
2.
Allow List:
Enter the IP Address(es) for the clients that you wish to allow. Note that
if an IP Address is found in the Allow list, the client will be allowed to connect, and
the RSM-8R will not check the Deny list.
a)
Text Interface:
Note the number for the first empty field in the Allow list, then
type that number at the command prompt, press
[Enter]
, and then follow the
instructions in the resulting submenu.
b)
Web Browser Interface:
Place the cursor in the first empty field in the
parameters menu, then key in the desired IP Address, operators, wild cards,
and/or net/mask pairs.
3.
Deny List:
Enter the IP Address(es) for the clients that you wish to deny. Note that
if the client’s IP Address is not found in the Deny List, that client will be allowed to
connect. Use the same procedure for entering IP Addresses described in Step 2
above.