5-3
Basic Operation
5.1.2. The Web Browser Interface
The Web Browser Interface consists of a series of web forms, which can be used to
select configuration parameters and perform reboot operations, by clicking on buttons
and/or entering text into designated fields.
Note:
In order to use the Web Browser Interface, Web Access must first be
enabled via the Text Interface Network Parameters Menu (/N), the VMR/NPS
must be connected to a TCP/IP network, and your PC must be equipped with a
JavaScript enabled web browser.
1. Start your JavaScript enabled Web Browser, key the VMR/NPS IP address
(default = 192.168.168.168) into the web browser’s address bar, and press
[Enter]
.
2.
Username / Password Prompt:
A message box will prompt you to enter your
username and password. The default username is "
super
" (all lower case, no
quotes), and the default password is also "
super
".
3. If a valid username and password are entered, the Plug Control Screen will be
displayed.
Note:
If a Login Banner has been defined as described in Section 6.2, then a
banner page will appear before the command prompt is displayed. The Login
Banner can be used to display legal warnings or other information.
5.1.3. The WMU Enterprise Management Solution
The WMU Enterprise Management Solution provides a centralized interface that can be
used to configure, manage and control multiple WTI out-of-band management devices
spread throughout a large corporate network infrastructure. When installed at your
network operation center or support facility, the WMU eliminates the need to individually
access WTI units in order to perform firmware updates, control power switching
functions, edit user accounts and perform other management and control functions.
The WMU software and user's guide can be downloaded at:
ftp://wtiftp.wti.com/pub/TechSupport/WMU/WtiManagementUtilityInstall.exe
