10.4. Command Set
This Section provides more detailed information on all CMS commands, sorted alphabetically by
name.
[Enter] Enter Command Mode
In order to set parameters or connect ports, you must first access the command mode as
described in
Section 5.1
. When the Command Mode is inactive (port asleep), the port will only
respond when the [Enter] key is pressed without any characters preceding it. If the Supervisor
Password (command /F) has been defined, the unit will require a password before allowing
access to Command Mode.
Availability: Supervisor / User
Format: [Enter] (Press [Enter] twice if other characters have already been typed).
Response: The Port Status Screen will be displayed, followed by the "CMS>" command
prompt.
[Enter]+++[Enter] Resident Disconnect Sequence
The Resident Disconnect Sequence is issued to disconnect your resident port from another port.
For example, if you are communicating via Port 3, and Port 3 is connected to Port 4, the
Resident Disconnect Sequence would be used to disconnect Port 3 from Port 4. Although the
default Resident Disconnect Sequence is [Enter]
+++
[Enter], the command format and Logoff
Character can also be redefined via the Port Configuration Menus as described in
Section 5.5.3
.
Note that a one character disconnect command can also be selected.
Availability: Supervisor / User
Format: [Enter]
xxx
[Enter]
Where "
x
" is the selected Logoff Character, and the default character is "
+
".
Response:
Verbose: The CMS will send the "Disconnected" message, followed by the Port Status
Screen.
Terse: 3
/C Connect
