WTE TReX-460, User Manual

Page: 248 / 302

TReX User Manual v15.30 Firmware
Repeater Operation Modes
The TReX is able to be used in a variety of repeater configurations depending on the
application.
Store forward and DMR licenses are required for these modes of operation.
Store Forward
In this mode, a TReX can intercept a POCSAG paging message, either from a WTE transmitter
or a third party paging transmitter. This message, after being received is then transmitted
again. In this mode, the receiver must be configured to the same settings as the POCSAG
message that is to be received, and the transmitted message is identical. The transmitted
message may be on a different frequency if required. Duplicate reject and delay before
retransmission is configurable. This is the simplest mode to configure for repeating POCSAG
messages.
DMR Translate Repeat
This mode is the same as the Store Forward mode, but incoming POCSAG messages that are
intercepted can be retransmitted as a DMR message. All DMR messages can be transmitted as
a different “Group” ID if required. Concurrent transmission to POCSAG devices is possible.
Duplicate reject and delay before retransmission is configurable.
Multi-Site Repeat
This is the most useful and configuration method that should be used to control multiple sites
when operated by a supervisory PC or system.
This mode allows any message to be sent to a wide coverage star system of repeating TReXs.
Each message can be sent to all repeaters at high speed, and allows for many different paging
types to be supported, as well as DMR messaging without the need to reconfigure any
repeating TReX. Ability to temporarily change frequency for pagers and DMR radios is also
possible.
Messages can be easily steered to all remote TReX units, or to a selection as required.
Duplicate reject and delay before retransmission is configurable.
© WTE Limited, 2022 – Christchurch New Zealand
Page 248 of 302