WTE TReX-460, User Manual

Page: 128 / 302

TReX User Manual v15.30 Firmware
System Commands
*TREX_LANG
Specifies the language used by the unit
*TREX_LANG=X
<CR>
where:
0 = English
Typical usage:
*TREX_LANG=0<CR>
*TREX_BACKLIGHT
Specifies the time in seconds which the display LED backlight will be lit for after a key is
pressed. Setting to 0 disables. Setting to 30 enables permanently. This command is also used
to set the LCD contrast. The default LCD contrast value is 32.
Typical usage:
*TREX_BACKLIGHT=10,32<CR>
*TREX_SOUND
Controls sounds made when a key is pressed or when a message is received that results in an
ALERT being raised.
Typical usage:
*TREX_SOUND=1<CR>
*TREX_RS232
Sets the serial baud rate of the RS232 port. The second parameter should be set to 1 if EVEN
parity is required.
Typical usage:
*TREX_RS232=9600,0<CR>
© WTE Limited, 2022 – Christchurch New Zealand
Page 128 of 302