WTC DEP 300s, User Manual

Page: 26 / 137

M035030-V2.0-Q06905/07-2017
23 of 40 Connect to the weld control via the serial network
BACKUP / RESTORE
The Backup / Restore feature allows the user to transfer data files
between weld timers. The DEP-300s is capable of uploading and
storing three weld timer programs in flash memory and then restoring
(downloading) them into other weld timers.
THE FOLLOWING LISTS WHAT WELD TIMER PARAMETERS ARE
BACKED-UP AND RESTORED:
NOTE: In order to transfer data from one weld timer to another, both
weld timers must have the same firmware program and revision
numbers.
NOTE: Always configure the weld timer to the desired timing (Cycle/
Ms) prior to performing a restore. For example, Msec data from a
weld timer that is being restored to one that was previously
configured for cycle timing will not convert to Msec. and the values
displayed may be erroneous.
PARAMETER BACKUP RESTORE
Setups
 
Schedule
 
Steppers
 
Stepper Status
 
Welder ID
 
FieldBus Options

FieldBus Inputs

FieldBus Outputs

Local Ethernet Address

EIP Configuration

EIP Configuration

EIP Inputs

EIP Outputs

DIO Outputs

Network Address
