WTC DEP 300s, User Manual

Page: 113 / 137

M035030-V2.0-Q06905/07-2017
110 of 120
STEPPER STATUS MENU
The Stepper Status Menu allows the user to view the status of any
stepper program within the weld control. Stepper programs can also
be advanced and reset form this menu.
The information shown in the Stepper Status display is based on
the stepper used by the schedule selected for a device.
The Stepper Status display cannot be used to program the stepper
profile or to set the stepper parameters. To do this, you must press
the PROGRAM MODE key and press for the Review Stepper menu.
(For more information, see “Level 1. 2: Review Stepper Menu” on
page 63)
BACK
Press to return back to the previous Status
Menu screen.
ADVANCE
Press to advance the stepper program to
the first weld of the next step. When the stepper
advances, the following changes will occur in the
Stepper Status Screen:
• The Step Count will reset to zero.
• The Total Weld Count will advance to
where its count would be at the first weld of
the next step.
• The Aux. Counter will not change when the
stepper is advanced. If the user wants the
Aux. Counter count to match the Total Weld
Count, the value will have to be manually
entered here.