Continue to drill the pearl until the Drilling Handle is being pushed to the
LEFT end and the Location Pin collided with the adjustable screw.
Step 13.
Pull back the Drilling Handle to the RIGHT end and turn “OFF” the switch
box.
Release the Stepping Pan due to squeeze the Pearl Clamp. The drilled
pearl will fall onto the Transfer Pan and transport to the container
Caution:
If user found out the Pearl cannot be drilled through, please adjust the
Compensation Screw (See Figure 9) which is at the right bottom side of
the main body to adjust the suitable compensation distance between
two Ground Bit Inserts when drilling.
Figure 9
Step 14.
Step 15.
#
The Ground Bit Insert must be ground well before use, otherwise it cannot
drill any hole and will burst out! The grinding method and the sample of the
ground bit insert are shown in appendix.
Please read the specification label on the Driving Motor carefully and
ensure that the input voltages must fit in the current country. Otherwise,
using incorrect input voltages can damage the machine!
Please ensure the Power Switch is on the “OFF” position before connecting
the power source!
* Caution!
1.
2.
