wsm M6060, Workshop Manual

Page: 45 / 639

GENERAL M6060, M7060, WSM
G-22
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plugs (2) at the bottom
of the engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining reinstall the drain plugs (2).
3. Fill with the new oil up to the upper notch on the dipstick.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-13.)
9Y1210828GEG0012US0
Replacing Engine Oil Filter
CAUTION
• Be sure to stop the engine before changing oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter (1).
2. Put a film of clean engine oil on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, fill the engine oil up to the prescribed level.
IMPORTANT
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210828GEG0013US0
Oil capacity with filter
12 L
12.7 U.S.qts.
10.6 Imp.qts.
(1) Oil Inlet
(2) Drain Plugs (A) Oil level is acceptable within this
range.
(1) Engine Oil Filter
KiSC issued 08, 2013 A