wsm Kubota L4100, Workshop Manual

Page: 336 / 346

ELECTRICAL SYSTEM L4100, WSM
9-S19
(EU)
(10) Hazard Switch and Beacon Switch
Hazard and Beacon Switch Continuity
1. Measure the resistance with ohmmeter between the a terminal
and c terminal, between the d terminal and e terminal.
2. If the measurement is not the same as below, the hazard (1) or
beacon switch (8) or the bulb is faulty.
9Y1210278ELS0016US0
(11) Flusher Unit
Flasher Unit action Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to 85 flashes for a minute.
2. With the main switch and the hazard switch at the ON positions,
respectively, move the turn signal switch to the left. make sure
that the right-hand light stays on and the left-hand light gives
flashes earlier (by about 20 flashes) than when the hazard lamp
is activated. Then move the turn signal switch to the right and
make sure the corresponding actions take place.
3. now set the main switch to the ON position and move the turn
signal switch alone. Make sure the same actions as above
result.
4. If both the hazard switch and the turn signal switch function but
the above actions do not take place, replace the flasher unit with
new one.
9Y1210278ELS0020US0
Resistance
(Switch at
OFF )
a Terminal –
c Terminal
Infinity
Resistance
(Switch at
ON )
a Terminal –
c Terminal
0 Ω
Resistance
(Bulb) d Terminal –
e Terminal
Approx. 13 Ω
(1) Hazard Switch
(2) Bulb
(3)
a Terminal
(4) b Terminal
(5) c Terminal
(6) d Terminal
(7) e Terminal
(8) Beacon Switch
(1) Hazard Switch
(2) Turn Signal Switch (3) Flasher Unit
KiSC issued 08, 2012 A