FRONT AXLE
L4100, WSM
6-S5
(EU)
Adjusting Front Axle Pivot
1. Jack up the tractor body, then loosen the lock nut (2).
2. Measure the adjusting screw tightening torque.
3. If the measurement is not within the factory specifications,
adjust the adjusting screw (1).
4. After adjustment, tighten the lock nut firmly.
(When reassembling)
9Y1210278FAS0006US0
[2] PREPARATION
(1) Separating Front Axle Case From Front Axle Frame
Draining Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove the drain plug (3) both sides and filling port plug (2) to
drain the oil.
3. After draining, reinstall the drain plugs (3) and filling port plug
(2).
(When reassembling)
• Remove the filling port plug (2) and right and left check plugs
(1).
• Fill with the new oil.
• After filling, reinstall the port plug (2).
IMPORTANT
• Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-9.)
9Y1210278FAS0007US0
Tightening torque
Front axle rocking force
adjusting screw
20 to 29 N·m
2.0 to 3.0 kgf·m
15 to 21 lbf·ft
Lock nut
40 to 58 N·m
4.0 to 6.0 kgf·m
29 to 43 lbf·ft
(1) Adjusting Screw
(2) Lock Nut
Front axle case oil
Capacity
6.5 L
6.9 U.S.qts
5.7 Imp.qts
(1) Check Plug
(2) Filling Port Plug
(3) Drain Plug
KiSC issued 08, 2012 A
Summary of Contents for Kubota L4100
