This publication has been made by Diesella A/S, Marsvej 20, DK-6000 Kolding (
Publication: 50615220-WRKPRO-F6X-INSTRUCTION_UK_DK
Date:
22-06-2019
Operating instruction (UK)
WRKPRO Work Lamp
“
F6X
”
Item no. 50615220
Intended Use
The product is intended to be used as a mobile inspection light source.
It’s
practical size and function makes
it easy to carry in a pocket and/or in a shirt pocket by using the clip. The magnetic function makes it possible
to attach to any suitable, magnetic surface and thereby giving way for a hands-free operation. The operation
of the product requires a rechargeable battery of the type 16,8V 4000mAh (which is included in the product).
If you use the product for purposes other than those described above, the product may be damaged.
Furthermore, an improper use involves risks such as short-circuits, fire etc. Please read the operating
instructions carefully and do not discard them. If you pass the product on to a third party, please hand over
these operating instructions as well.
This product complies with the applicable National and European legal
requirements. The WRKPRO brandname is a trademark owned by Diesella A/S. All rights reserved.
Package Contents
•
LED work light
•
Rechargeable battery 16,8V 4000mAh Li-Ion
•
Charging adaptor and USB cable
•
Operating instructions
Explanation of Symbols
An exclamation mark in a triangle indicates important instructions in this operating manual which
absolutely
MUST BE OBSERVED
.
The arrow symbol is used when specific tips and information on handling are provided.
Safety Instructions
Please read the operating instructions carefully and pay attention to the safety
instructions. We do not cover liability for injuries/material damages resulting from fail-
ure to observe the safety instructions and the information in these operating instructions
regarding the proper handling of the product. Furthermore, in such cases, the warranty/
guarantee of the product will no longer be valid.
a)
General
•
The product is not a toy. Keep out of the reach of children and pets.
•
Do not leave packing materials unattended. It may become a dangerous plaything for children.
•
The product is designed for use indoors and outdoors. However, it must not be used in or
under water, as this will destroy it.
•
Protect the product from extreme temperatures, direct sunlight, strong vibrations and
combustible gases, vapors and solvents.
•
Never expose the product to mechanical stress.
•
If safe operation is no longer possible, take the device out of service and secure it against
unintended use. Safe operation is no longer possible, if the product:
-
has visible damage,
-
no longer functions properly,
-
has been stored under adverse ambient conditions for an extended period of time or
-
has been exposed to considerable strain during transport.
•
Please handle the product carefully. The product can be damaged if crushed, struck or drop-
ped, even from a low height.
•
Do not look directly into the LED light!
•
Do not look directly or with optical instruments into the light!
•
Maintenance, adjustment and/or repair work may be carried out only by an expert or a
specialist workshop ONLY!
•
If you have any questions, that are not answered in these operating instructions, please con-
tact our technical customer service or another specialist.
•
If the work lamp offers the possibility of changing the battery (directions are found in the
section “Inserting batteries, replacing batteries” –
then please observe the correct polarity
when placing the rechargeable battery into the unit.
•
If you are not going to use the device for a while, remove the rechargeable battery to prevent
damage from leaking. Leaking or damaged rechargeable batteries can cause acid burns
upon contact with the skin. Thus, you should wear protective gloves when handling damaged
batteries/rechargeable batteries.
•
Keep the rechargeable batteries out of the reach of children. Do not leave batteries lying
around, as they may be swallowed by children or pets.
•
Replace all the rechargeable batteries at the same time. Mixing old and new rechargeable
batteries or mixing different rechargeable batteries in the device may lead to battery leaks
and will thus damage the device.
•
Do not dismantle rechargeable batteries, do not short-circuit them and do not throw them
into fire. Never charge conventional, non-rechargeable batteries. There is a danger of
explosion!
Inserting Batteries, Replacing Batteries
•
Please note: This product is pre-installed with a rechargeable battery!
IMPORTANT NOTICE ABOUT THE BATTERY:
•
THE BATTERY OF THIS PRODUCT CANNOT BE CHANGED!
•
DO NOT TRY TO DISMANTLE THE PRODUCT
–
THE WARRANTY WILL BE VOID.
Operating and charging procedure
Operation:
•
Turn on the LED inspection lamp by pressing the on/off switch
“ ”.
•
1
st
push on the on/off switch
“ ” activates the light in lowest brightness mode.
•
To increase the brightness, push the “+” button.
•
To decrease the brightness, push the “
-
” button.
•
The brightness can be adjusted in 7 steps (500 / 1000 / 1500 / 2000 / 2500 / 3000 / 3500 Lumens).
•
To turn off the lamp, push on the on/off switch
“ ”.
Power bank function
•
Remove the protection cover for the USB charging connector located on the upper part on the backside
of the work lamp.
•
First connect the USB cable to the USB charging socket, then connect the cable to your device.
•
The charging will start immediately when the device has been connected.
•
Unplug the charging cable to stop charging. Remember to put the protection cap in the socket after use
to prevent dirt and/or moisture from entering.
Charging the battery:
•
Turn off the lamp before charging
•
Remove the charger protection cap located on the top of the back side.
•
Now connect the charger cable to the work lamp and then to the charger adapter - then turn on the power.
•
The battery indicator will start to blink when charging has started. When charging is complete (= battery
fully charged), the light indicator will remain in constant blue color.
•
Use only the included adapter and USB cable! Any non-recommended charger and / or USB cable can
cause fire and eventually damage the lamp.
Care and Cleaning
•
Never use abrasive cleaning agents, cleaning alcohol or other chemical solutions, since these could
damage the enclosure or even impair operation.
•
Use a dry, lint-free cloth to clean the product.
Disposal
a)
Product
Electronic devices are recyclable material and do not belong in the household waste. Dispose of
the unserviceable product in accordance with the relevant statutory regulations.
Remove any inserted batteries/rechargeable batteries and dispose of them separately from the
product.
b)
Batteries/rechargeable batteries
As the end user, you are required by law (Battery Ordinance) to return all spent batteries/rechargeable
batteries; disposal of them in the household waste is prohibited.
Batteries/rechargeable batteries contain harmful materials and are labelled with the symbol
shown to indicate that disposal in the household waste is forbidden. The symbols of the critical
heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (the marking can be seen on the battery/
rechargeable battery, e.g. underneath the refuse bin symbol shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the official collection points of
your community, in our stores, or at places where batteries or rechargeable batteries are sold.
You thereby
fulfil your statutory obligations and contribute to the protection of the environment.
Technical Data
LED light source: ......................... COB LED
Max. output: ................................ 3500 Lumens
Min. output: ................................. 500 lumens
Run time: .................................... 2 - 12 hours
Operating voltage: .......................
16,8V 4000mAh Li-Ion battery
Charging time:............................. 3 hours
Charger: ...................................... 16,8V DC 2A
Protection class: .......................... IP54
Operating/storage conditions: .....
-10° C to 40° C
, max. 93% relative humidity, non-condensing
Dimensions: ................................ 211 x 211 x 64 mm
Weight: ........................................ 1458 g
Reservations are made for printing errors and / or errors describing the product