Page
4
of
9
WIM-PD-005 REV_A
If the product is fitted with fusible plugs, the ventilation openings should not be directed towards
operators or any hot or electrical installation.
3.0 Installation
CAUTION
Before mounting the pump drive onto the engine, it is important to check that the flywheel is within
SAE tolerances.
3.1
Check that the flywheel is within SAE tolerances (see Figure 1).
3.2
Mount aluminum drive ring of the elastic coupling to the flywheel.
Figure 1: Checking that the flywheel runout is within SAE tolerances.
3.3
Mount the pump drive on the flywheel housing of the engine keeping in mind
to align the teeth of the elastic coupling in the respective teeth of the driving
ring. To align the pump drive housing and flywheel housing, use three threaded
rods with adequate lengths, mounted 120° apart on the flywheel housing. To
perform this operation, lift the assembly by using straps or other approved
means. In cases where the configuration includes a power take-off, support the
assembly adequately to ease alignment.
3.4
Mount the pump(s) on the head(s). Utilize pump manufacturers recommended
grease on both internal and external splines of the adapter.
3.5
Read pump(s) and other installed devices maintenance manual to assure
proper lubrication.