Page
3
of
9
WIM-PD-005 REV_A
1.0 Introduction
The WPT Power Pump Drive model WPD-05 is an innovative modular pump drive designed to be
mounted on industrial engines with SAE flywheels and housings. The input is a rugged Rubber Block
Drive flywheel coupling. This elastic coupling absorbs radial and angular misalignments as well as
dampens torsional vibrations. The model WPD-05 output is a dual pad pump drive as well as SAE
flywheel and flywheel housing. To allow for easy installation the pump tower can be mounted in 12
possible positions over 360 degrees. The output flywheel can accept transmissions, pumps,
compressors,
and PTO’s.
Throughout the manual there are several HAZARD WARNINGS that must be read and followed to
prevent possible loss of equipment and/or personal injury and/or loss of life. The three warning words
are “DANGER”, “WARNING” and “CAUTION”. They are used to indicate the severity of the hazard and
are preceded by a safety alert symbol.
DANGER
Denotes the most serious injury hazard and is used when serious injury or death WILL result from
misuse or failure to follow the specific instructions sit forth in this manual.
WARNING
Denotes when serious injury or death MAY result from misuse or failure to follow the specific
instructions set forth in this manual.
CAUTION
Denotes when injury, product or equipment damage may result from the misuse or failure to follow
the specific instructions set forth in this manual.
2.0 General Warnings
Before assembling and operating the product, carefully read all the safety and operating instructions in
this manual.
Always follow all the instructions and make sure that all operators standing by the machinery are
wearing protective equipment necessary for the job type and application being performed.
WARNING
Do not use the machinery if you do not understand these instructions. Please refer to the
manufacturer or customer service for assistance.
WARNING
The product must be protected by a convenient cover guard to avoid personal injury or injury to
others.
Axial and radial ventilation openings should be incorporated in the guard for heat dissipation.