WIM-HB-000_A
Page
9
of
21
5.0
Disassembly
5.1
Disassembly of Hydrodynamic Brake Housing
5.1.1
Remove all sheaves, belts, and other devices from shaft of unit.
5.1.2
Remove unit from customer supplied supporting plates.
5.1.3
Starting from shaft-less side.
5.1.4
Remove hardware securing bearing adapter, do not remove hardware on cover plate.
5.1.5
Use jack screws to help in removing bearing adapter and remove bearing from shaft.
5.1.6
With bearing adapter removed from assembly proceed to remove hardware to
remove cover plate.
5.1.7
Separate seal from cover plate.
5.1.8
Inspect seal for reuse or replacement.
5.1.9
Remove bearing from bearing adapter.
5.1.10
Inspect bearing for reuse or replacement.
5.1.11
Remove sleave from shaft.
5.1.12
Remove O-ring.
5.1.13
Remove hardware from cap to remove cap & O-rings.
5.1.14
Remove left hand stator and O-rings.
5.1.15
Remove center ring.
5.1.16
Remove left hand rotor.
5.1.17
Remove key.
5.1.18
Remove right hand rotor.
5.1.19
Change to removing items from in-put side (shaft side).
5.1.20
Remove hardware securing bearing adapter, do not remove hardware on cover plate.
5.1.21
Use jack screws to help in removing bearing adapter and remove bearing from shaft.
