WIM-HB-000_A
Page
12
of
21
***LEFT/LEFT OR RIGHT/RIGHT MATCHING VANES***
CONFIRM LEFT STATOR FACES LEFT ROTOR AND SAME FOR RIGHT SIDE
6.2.6
Grease new O-Rings with Synxtreme HD-2/220 and install both in center ring.
6.2.7
Position stator on top of center ring. The 3” NPT inlet in center ring must be centered among
seven
inlet holes along edge of stator face, likewise the 2” NPT outlet on center ring must align with the
one inlet hole along edge of stator face.
6.2.8
Grease O-Ring with Synxtreme HD-2/220 and install in grove of stator.
6.2.9
Grease O-Ring with Synxtreme HD-2/220 and install in grove of cap.
6.2.10
Place back side cap in position on top of center ring-stator assembly with the group of four
mounting bosses on cap surface nearest to the 3” NPT i
nlet. Bolt with 22-cap screws through holes
in center ring and secure with 22-lock washers and nuts on cap surface. Insert cap screws and
washers into cap and tighten.
6.3
Drive Side & Back Side Bearing/Seal Adaptor Assembly
6.3.1
Grease O-ring with Synxtreme HD-2/220 and slide O-RING in place on shaft.
6.3.2
Slide seal sleeve on shaft over O-Ring pushing tab at back of sleeve into notch provided in shaft. Seal
sleeve should not extend over stepped portion of shaft when sleeve is located properly.
6.3.3
Coat bore of bearing adapter with Loctite (596 RTV) in location where seal seats. Press seal into bore
making sure that seal lip is pointed inward. Do not hammer directly on seal case.
6.3.4
Coat bore of seal adapter with Loctite (596 RTV) in location where seal seats. Press seal into bore
only enough that steel case is flush with flange.
NOTE: Make sure that seal lip is pointed inward. Do not hammer directly on seal case.
6.3.5
Coat bore of cover plate with Loctite (596 RTV) in location where seal seats. Press seal into bore
making sure that seal lip is pointed inward.
6.3.6
Mount back side seal adapter to bearing adapter with eight socket-headcap screws
6.3.7
Grease O-Ring heavily with Synxtreme HD-2/220 and position in groove on backside of seal adapter.
6.3.8
Grease seal lips and bore of brake housing with Synxtreme HD-2/220, then slide bearing adapter
assembly into bore making sure threaded Zerk hole at outer edge of bearing adapter is at brake top
and unthreaded hole at outer edge is on bottom. During positioning of adapter assembly in bore,
care must be taken that seal lips slide over seal sleeve without turning backwards and the O-Ring
does not drop from position. Secure bearing adaptor with socket head cap screws with lock washers.
6.3.9
Bearing outer race is a slip fit and inner race is a press fit. When driven on, start inner race on shaft
until outer race is seated against bearing adapter. Cover both inner and outer races with protective
plate to distribute press force, otherwise breakage of races may result. Bearing is positioned
properly once bearing inner race contacts shoulder on shaft
NOTE: Rotor-Stator Spacing Must Be Measured to Correctly Center Rotor with Proper Operating Clearance.
