FlashCut CNC
Section 3
To Install On Your System
7
3.
To install on your system:
1.
Open up FlashCut CNC
(Must be version 3.0.14 or greater) If you have an earlier
version, then you must install version 3.0.14 or greater before proceeding.
2.
Plug the end of the USB cable into an empty USB port on your computer.
3.
Select Configuration on the Main Screen’s Pull-Down menu, followed by Preferences
and Pendant
4.
In the Pendant Configuration Menu, select the check box next to “Use Flex Pendant.”
5.
Then press the “Use Standard Layout” button and select OK to set the pendant
buttons to their default functions.
6.
The pendant is then configured to work with the FlashCut CNC software.
7.
Press the buttons to perform each of the functions. Note that there are two layers that
you can choose using the Layer Key on the bottom left. This key chooses between
the Green and the Red layers. Note that all of the Jog and Home functions are in the
Green layer. All other functions are on the Red layer.
8.
There is a dial on the upper right edge of the pendant that is taped in one position for
normal operation. Please do not remove the tape or try to reposition the dial.
