Rev 34.7/3-20
4
MR1611LDC: #35050
WARNINGS
Powr-Grip is pleased to offer the most reliable vacuum lifters available.
Despite the high degree of security provided by this product, certain
precautions must be observed to protect the operator and others.
Always wear personal protective equipment that is appropriate for the material being handled.
Follow trade association guidelines.
Always operate the lifter under conditions approved for its design (see INTENDED USE:
O
PERATING
E
NVIRONMENT
).
Never operate a lifter that is damaged, malfunctioning, or missing parts.
Never operate a lifter if the sealing edge of any vacuum pad is cut or otherwise damaged.
Never remove or obscure warning labels.
Never operate a lifter if the Maximum Load Capacity or any warning appears to be missing or
obscured.
Always make certain the contact surfaces of the load and all vacuum pads are clean prior to
attaching the pads (see MAINTENANCE: V
ACUUM
P
AD
M
AINTENANCE
).
Never exceed the Maximum Load Capacity or attempt to lift loads that the lifter is not designed
for (see INTENDED USE: L
OAD
C
HARACTERISTICS
).
Never attempt to lift cracked or broken glass with this lifter.
Always position the vacuum pads correctly on the load prior to lifting (see OPERATION: T
O
A
TTACH THE
P
ADS TO A
L
OAD
).
Never lift a load when any vacuum indicator shows inadequate vacuum.
Never touch the vacuum release controls during a lift. This may result in loss of vacuum and
release of the load.
Never allow people to ride on the lifter or the load being lifted.
Never lift a load higher than necessary or leave suspended loads unattended.
Never lift a load over people.
Always keep other personnel far enough away from the lifter to avoid injury in the event of an
unexpected load release.
Always place the power control in the inactive position and, when possible, disconnect the
power source before opening any enclosure on the lifter. (Only applicable to powered lifters)
Always remember that modifications to the lifter could compromise its safety. Wood’s Powr-
Grip cannot be responsible for the safety of a lifter that has been modified by others. For
consultation, contact Wood's Powr-Grip (see LIMITED WARRANTY).
If the lifter is equipped with a Remote Control System,
never operate the lifter remotely unless
there is clear communication about intended actions (eg, releasing load) with all personnel
near the lift. In addition, the operator must visually verify the status of the lifter and load
prior to remote operations.
Summary of Contents for MR1611LDC
