Operation—Operator's Station
OUT4001,0000745 -19-13AUG14-1/1
OUT4001,0000779 -19-19FEB18-1/1
Cab Dome Light Switch
The cab dome light is located on the right side of cab roof.
There are three operating positions:
•
ON (1):
The cab light turns ON and stays ON until
switch is moved to the OFF position.
NOTE: The cab light
will NOT
turn ON if the key
switch is in OFF position.
•
Cab door—middle position (2):
The cab light turns
ON when the door is opened. When the cab door is
closed or cab door is left in the open position, the cab
light turns OFF automatically after 30 seconds.
NOTE: The cab light
will
turn ON if the key
switch is in OFF position.
•
OFF (3):
The cab light turns OFF and stays OFF until
switch is moved to the cab door—middle position or
ON position.
TX1086802A
—UN—1
1JAN1
1
Cab Dome Light Switch
1— ON
2— Cab Door—Middle Position
3— OFF
Opening Upper Front (Alternative Exit)
Window
NOTE: The wiper cannot operate with the upper front
window open. The washer can operate with
the upper front window open.
1. Park machine on a solid, level surface.
2. Lower equipment to the ground.
3. Stop engine and pull pilot shutoff lever to locked (UP)
position.
4. Lift the lock pin (1) up, slide inward, then slide down
into notch.
5. Pull the lock release bar (2) toward operator.
6. While holding the lower handle on the window, pull
window up and guide all the way back on track until
window locks into position.
CAUTION: Prevent possible injury from window
closing unexpectedly. Always lock the pin
in the cab frame boss hole.
7. Slide the lock pin into the cab frame boss hole and
rotate downward into the lock position.
CAUTION: Prevent possible injury when closing
the upper front window. Upper front window
TX1087290A
—UN—25JAN1
1
Upper Front Window
1— Lock Pin
2— Lock Release Bar
comes down forcefully. Close window only
when sitting in operator’s seat.
8. To close upper front window, unlock pin and pull lock
release bar down. Hold lower handle on the window
and guide window down the track slowly until window
clicks into position. Install lock pin.
2-1-13
092221
PN=72
Summary of Contents for 380GLC
