4
Cutout for hybrid slot reader
2.1
DIMENSIONS FOR THE DEVICE’S FRONT PANEL CUTOUT
When installing the components in the device front, the cut-
out dimensions detailed in this document must be applied.
Particular consideration should be given to the torque used
for the screws/ nuts, otherwise proper operation cannot be
guaranteed.
Figure: Cutout for the device front for the davinci reader and RFID reader
Welding studs M5 (4x)
DEVICE FRONT CUTOUT
Please note
(Applies to all assemblies)
•
The device front into which the contact card reader is installed may have a maximum thickness of 6.6 mm.
•
The nuts/screws used to affix all components must be tightened with a torque of 0.8 Nm (± 10%).
The same also applies to the 4 screws that hold the mouthpiece module together.
•
The external 4 screws (affixing the reader to the device front) may have a maximum torque of 0.3 Nm for the final
tightening step.
2 Installation
