Worldlawn DIAMONDBACK, Operator'S Manual, Page: 21 / 56

21
FUEL SHUT-OFF VALVE
Located behind the seat in front of the engine.
The fuel shut-off valve is used to shut off the
fuel when the machine will not be used for a
few days, during transport to and from the
jobsite, and when parked inside a building.
Align valve handle with the fuel line to open.
Rotate to horizontal position to close.
IGNITION SWITCH
Located on the control console. See below for
complete Digital Console operating instructions.
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”,
“ON” and “START”. Insert key into switch and
rotate clockwise to the “ON” position. Rotate
clockwise to the next position to engage the
starter (key must be held against spring
pressure in this position). Allow the key to
return to the “ON” position immediately after the
engine starts.
NOTE: To start the engine, the
control levers must be in the neutral positions,
park brake must be on, and blade switch must
be off.
HOUR METER
Located on the control console
The hour meter records the number of hours
that the engine has run.
DIGITAL CONSOLE INSTRUCTIONS
LCD Information Center
Engine hour meter
– accumulative
counting, non-resettable
Mower hour meter
– accumulative
counting, non-resettable
Job time
– resettable
Time of day clock
Tachometer
(RPM)
Volt meter
– with low and high warning
Service Alerts
– engine oil, hydraulic oil
and air filter
NOTE
– Your LCD may not display all icons as
shown below
1. Mower PTO Knob Pull up to engage blades,
push down to disengage.
2 . LCD Quick Toggle Buttons: Depress and
release to toggle between modes, depress and
hold down for 6-9 seconds to reset/clear
(Display shows “00000” when reset occurs)
NOTE: console must be powered up.
3. LED Indicators : Monitors equipment and
operator conditions, alert the operator when
necessary.
4 . Key Code Buttons: Use to unlock and
power up.
5 . Headlight Button: Push and release to
turn headlights on, repeat to turn headlights off.
NOTE: Your console may have a headlight
button but not be equipped with headlights.
Contact your dealer to purchase this accessory.
6. Service alert Button: Depress to access
maintenance requirements and intervals. To
reset depress and hold down for 6-9 seconds
(Display shows “00000” when reset occurs)
NOTE: Only service alerts are resettable when
console is powered up.