Worldcast Systems AUDEMAT FM PROBE, User Manual

Page: 6 / 80

AUDEMAT FM Probe 1.2.x User Manual
– 07/2021
Page 6
WorldCast Systems SAS - 20, avenue Neil Armstrong – 33700 Merignac – Bordeaux Métropole (France)
+33 (0)5 57 928 928 – contact@worldcastsystems.com – www.worldcastsystems.com
With 5 or 8 receivers:
In this mode, the 3 receivers can cover the full FM Band and it is possible to monitor continuously up to 8 FM
programs or to combine continuous monitoring of up to 7 pr sequential monitoring of a list of FM programs
on the remaining receiver(s).
•
Watermarking : enables detection and monitoring of Kantar wartermarks.
•
ScriptEasy SNMP: allows communication with 10 additional units using the SNMP protocol and the ScriptEasy
software (communication with 10 units is possible as standard).
See section 6.8.1 for software option activation.
1.3. Before you start
1.3.1. Safety warning
This equipment complies with international mechanical and electrical standards. To maintain this compliance, as well
as to ensure proper and safe working conditions and avoid electrical shocks and fire hazards, you must comply with
the following recommendations:
•
The device should only be utilized in the conditions described in the user manual.
•
The device is designed for industrial usage and must only be operated by qualified personnel.
•
The device may be heavy; it must be lifted and handled with care, specifically during unpacking and set up.
•
Rackable products must be set in cabinet with 19” rack mounting screws.
Electrical precautions
•
Disconnect all sources of power before any intervention.
•
Any maintenance, adjustment or repair must be carried out by personnel specifically trained by WorldCast
Systems.
•
Before switching on the device, make sure the nominal voltage specified on the device matches the mains
nominal voltage.
•
The device should only be operated on a stable electrical network. If the electrical network is not stable, a
power conditioner, such as a UPS, must be used
•
The device must only be used with a plug that incorporates a protective ground contact.
•
To avoid any risk of electrocution, the protective earthing conductor must not be cut, intentionally or
accidentally, either on the device or on the power cord.
•
High quality shielded cables are mandatory.